Transition T Profile

Page 1 of 1

You cannot start a new topic
You cannot reply to this topic

Transition T Profile

#1
xysoom

Posted 01 March 2023 - 06:53 AM

Advanced Member

Group: Members
Posts: 6,242
Joined: 21-May 20

Transition T Profile
Transition T profiles are used for joining different floorcoverings of the same, or slightly differing, heights. They are available in anodised aluminium and brass.Get more news about T Profile Edging,you can vist our website!

The design of the T profiles allows slight imperfections in joints and cuts to be hidden, and enables a gap between floor finishes to be incorporated during installation to allow for natural expansion in flooring materials such as ceramics and wood.

Profiles can be curved on-site for shaped edges and inlays.

T profiles are fitted after the floorcoverings have been installed, making them ideal for use when the installation of the floorcoverings is undertaken by different trades (e.g. ceramic contractors and flooring contractors) where the trims cannot be fixed until both floors have been completed.
Aluminum extrusion is conducted in a hot environment. Billets are heated at 420-520 °C, molds should be heated to 450 °C and the profile temperature coming out of the mold is 500 °C. Profile is cooled upon leaving extrusion, cold stretching is carried out and is cut in the desired lengths. Then profiles are treated with heat in order to gain strength. During this process, the profiles are held at 185 °C for five hours.

Our factory has 8 extrusion pres lines with different strength and sizes, that varies between 6-7-8-10 inch, in order to meet profile production demands of different sizes. With the production capacity of 70,000 tons annually, we can manufacture EN AW 1050, 1070, 6060, 6063, 6463-6005 alloys, as well as special alloys such as EN AW 6082.

A wide range of aluminium profile products for the purposes of various sectors and uses, are carried out in our extrusion lines.